The Trend KWJ900 Kitchen Worktop Jig is an all-in-one routing jig designed for fitting and jointing kitchen worktops up to 900mm wide, enabling tradespeople to cut both parts of a joint in as little as 15 minutes including setup. Machined from 12mm Compact Grade High Pressure Laminate, this CNC-precision jig is built to withstand the demands of regular site use. Fixed length markings accommodate worktop widths of 400mm, 500mm, 550mm, 600mm, 616mm, 635mm, 650mm, 700mm, and 900mm, covering the full range of standard UK kitchen unit configurations. The jig handles a comprehensive variety of joint types and cuts, including left and right hand corners, a 400mm radius peninsular joint, 45-degree end cuts with slight radius, a 45-degree trade corner solution for hob units, 100mm and 40mm radius corners, a 35mm kitchen door hole, and a ¾-inch BSP hole for mixer tap installation. It cuts worktops up to 40mm thick, with or without an anti-drip postformed edge. Setup is straightforward thanks to 10mm diameter ABS plastic pins with tapered shoulders, providing three-point pin contact for precise and repeatable positioning. Engraved markings identify pin holes clearly, while three open-ended dog bone bolt recesses and engraved lines for 65mm bolts and cross-cuts ensure accurate jointing every time. To use this jig, a portable plunge router with a ½-inch (12.7mm) shank and minimum 1,300W is required, along with a 30mm outside diameter template guide bush (ref. GB30), a ½-inch TCT router cutter with 50mm cut length, and two clamps. Features and Benefits: • All-in-one jig covering the full range of standard kitchen worktop joints and cuts • CNC machined Compact Grade HPL construction for durability and accuracy • Cuts both sides of a joint in approximately 15 minutes including setup • Compatible with worktops up to 40mm thick, including postformed anti-drip edges • Supports nine fixed worktop widths from 400mm to 900mm • ABS plastic tapered pins provide three-point contact for repeatable positioning • Includes dog bone bolt recesses for 150mm bolts and engraved lines for 65mm bolts • ¾-inch BSP tap hole and 35mm door hole templates included Specifications: Jig Material: Compact Grade High Pressure Laminate (HPL) Jig Thickness: 12mm Maximum Worktop Width: 900mm Maximum Worktop Thickness: 40mm Pin Diameter: 10mm Pin Material: ABS Plastic Bolt Recess Size (Long): 150mm Bolt Recess Size (Short): 65mm Door Hole Diameter: 35mm Mixer Tap Hole: ¾-inch BSP Required Router Shank: 12.7mm (½ inch) Required Router Power: 1,300W minimum Required Guide Bush Outside Diameter: 30mm (ref. GB30) Required Cutter Diameter: 12.7mm (½ inch) Required Cutter Cut Length: 50mm (2 inch) Contents: 6 x ABS Plastic Pins