600W Outdoor Rated AUTO Occupancy Motion Sensor Lighting SwitchPACK OF 2 Sensors Can be linked to together to control 1 set of lightsPlease note 3 Terminals on backLoad in, Load out and Neutral (Neutral must always be connected).Overview This occupancy switch is ideal for areas where lights and/or a fan are only required when the area is occupied. It works by detecting and monitoring body heat in an area, when the area becomes vacant, the switch will go off after a chosen and adjustable duration (10 seconds15 minutes). Perfect for use in toilets, warehouses and corridors to reduce the amount of electricity used and save money on energy bills. It is suitable for use with LED lights, fluorescent lights, incandescent lamps, energy saving lamps or fans. This light switch can be used as a replacement or new switch with a 250V rated consumer unit (fuse box) as found in most UK houses. It can be mounted to a wall or ceiling via the supplied fixing screws and thanks to its IP44 Rating, it be install outdoors or in bathrooms. If required, more than one of these PIR switches can be linked in parallel to make a circuit live, this could be useful at the top and bottom of a stair case Or in a larger space when all lights in that space need to be turned on at the same time, no matter where motion is detected in that space. Thanks to the clever design of this unit, you can twist off the front cap and gain easy access to the lux and timer controls. A lot of occupancy sensors on the market would require you to un-install the unit completely, as access to these controls may be on the rear or inside the switch. OCCPANCY With traditional PIRs, once the timer has started, thats it, you would then have to wave your hand or move when the light goes off to reset the light which can be frustrating. Our occupancy sensors will constantly reset their timer providing someone is within the sensors range. This means that any connected lights will only turn off when the switch hasn t detected movement for your selected period of time. Lux Our occupancy sensors have a lux setting which will only allow your lights to be turned on when a light level falls below are certain point and when motion is detected. For example, your garden lights won t come on during the day when you walk past them if you set the correct lux level. Timer When the switch is triggered, it will keep your lights on for a certain period of time. This switch has the following timer settings: 10 Seconds, 30 Seconds, 90 Seconds, 3 Minutes, 7 Minutes or 15 minutes. When motion is detected by the sensor, the timer will reset. This kit is supplied with wall / ceiling mounting screws. There are 2 blowout holes with weatherproof glands on the back of the unit and easy access screw terminals make for quick and safe installation of power cables. Specification:Detection Radius 360 DegreesDetection Range 6m Max ( 24 C)Installation Height 2.2m to 4mLux Settings 3 Lux to 2000 LuxTimer Settings 10 Seconds, 30 Seconds, 90 Seconds, 3 Minutes, 7 Minutes or 15 minutesTime Delays Minimum 10 seconds, maximum 15 MinutesMaximum Load 600W LEDIP Rating IP44 Suitable protection against weather and water sprays from any direction Power Source 110-240V ACPower Frequency 50/60HzGuarantee 2 YearsDimensions 90mm (diameter) x 50mm (Height)Standards ROHS | Loops 2x Outdoor / Bathroom PIR Occupancy Sensor Automatic Timer Reset Light Switch